How many rolls of wallpaper do I need?

Last checked: November 2026

Short answer: Count strips, not square feet. Strips needed = wall width ÷ roll width. Strips per roll = roll length ÷ (wall height + pattern repeat + about 4 in / 10 cm trim). Rolls = strips needed ÷ strips per roll, rounded up, plus one spare from the same batch.

Calculator (works in inches or centimetres — just keep one unit)

The default numbers are a 12 × 8 ft room papered on all four walls (480 in of wall), with a US double roll (20.5 in × 33 ft = 396 in) and a 21 in pattern repeat.

Why square-foot calculators often come up short

A US double roll is usually 20.5 in wide and 33 ft long, about 56 sq ft printed on the label. European rolls are about 0.53 m × 10.05 m, roughly 5.3 m². Those figures assume every inch of paper ends up on the wall. In practice each strip has to be cut a little longer than the wall for trimming, and with a patterned paper every strip has to start at the same point in the design. The paper between one usable drop and the next goes in the bin.

That waste is lumpy. If your wall is 8 ft high and the roll is 33 ft long, you get four 8 ft drops with a plain paper. Add a 21 in repeat and each drop becomes about 9 ft 9 in, and you only get three. That one lost strip per roll is a 25% difference, far more than the "add 10%" rule of thumb allows for.

Step by step by hand

  1. Measure the width of every wall you will paper and add them up.
  2. Count strips: divide by the roll width and round up. Do not subtract doors and windows yet.
  3. Work out one drop: wall height + pattern repeat + trim (about 4 in / 10 cm).
  4. Strips per roll: roll length ÷ drop, rounded down.
  5. Rolls: strips ÷ strips per roll, rounded up.

Doors and windows

A standard door takes away about one and a half strips over its width, but you still need short pieces above it. Our habit on site is to subtract one full strip for each door and ignore windows unless they are wider than a strip. That keeps a little spare for mistakes, which you will want.

Buy one extra roll from the same batch

Every production run of wallpaper is printed in a batch (also called a lot or dye lot). Rolls from different batches can be a shade apart, and the difference shows when two strips meet on a wall. Buy all the rolls from one batch, and buy one more than you need. A spare roll costs less than repapering a wall when you damage a strip later.

Related

How to calculate wall area · How much paint for a room · How to measure a room